Siemens SINUMERIK 840D sl Commissioning Manual page 501
Basesoftware and operating software
Hide thumbs
Also See for SINUMERIK 840D sl:
- Function manual (2184 pages) ,
- Programming manual (1334 pages) ,
- Diagnostic manual (1054 pages)
Table of Contents
Advertisement
MD20150 $MC_GCODE_RESET_VALUES[ ]
[41] = 1
[51] = 2
[52] = 1
[52] = > 1
Note
If, after a RESET from the NC, a frame must be calculated in the tool direction, then
MD20150 $MC_GCODE_RESET_VALUES[52] can be set to a value > 1.
Applications:
• Machine kinematics with Hirth gearing
• Angular tool with basic tool orientation
Note on kinematics (swivel head / mixed kinematics) with Hirth tooth system:
Depending on the active plane (G17,G18,G19), the TOROT command (or TOROTX,
TOROTY) is programmed in the NCU (G group 53) to calculate the compensating frame for
the Hirth gearing system in CYCLE800. If the Hirth gearing causes the programmed rotation
to deviate from the possible positions of the rotary axes, a $P_TOOLFRAME compensating
frame is created for swivel head and mixed kinematics (see HMI active ZO/details tool
reference).
If the compensating frame must be retained after RESET or end of part program, enter the
following value in the channel-specific machine data:
MD20150 $MC_GCODE_RESET_VALUES[52]
= 2
= 3
= 4
MD20196 $MC_TOCARR_ROTAX_MODE
Bit 0 = 1
Bit 1 = 1
SINUMERIK Operate (IM9)
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
Delete position, G group 42 on TCOABS
Delete position, G group 52 on PAROT
Delete position, G group 53 on TOROTOF
Delete position, G group 53 on TOROT, TOROTY or TOROTX
Used for machine kinematics, types "T" and "M"
See parameter $TC_CARR34
For G17 (TOROT)
For G18 (TOROTY)
For G19 (TOROTX)
Swivel data set with a rotary axis
used for a rotary table with C axis
Swivel data set with two rotary axes
used for standard swiveling
Configuring cycles
Delete position, G group.
Reset behavior of G groups
Rotary axis mode for toolholders with
orientation capability
22.6 Swiveling
495
Advertisement
Chapters
Table of Contents
