Siemens SINUMERIK 840D sl Commissioning Manual page 849
Basesoftware and operating software
Hide thumbs
Also See for SINUMERIK 840D sl:
- Function manual (2184 pages) ,
- Programming manual (1334 pages) ,
- Diagnostic manual (1054 pages)
Table of Contents
Advertisement
The following data is displayed for each interface:
● Name: the name of the connection socket (X1_ _), together with the name used by the
● "configured": the IP address configured in the basesys.ini (variables
● "current": the currently set IP address together with the network screen form and MAC
● "DNS Name": Result of a DNS reverse lookup on the current IP address.
● "Nameserver": Here the list of DNS servers is output which are related to this interface
● "DNS Suffix": DNS search suffix related to this interface.
● "DHCP": Indication is given here if a DHCP client or server is running for this interface. In
● "Statistics": Total amount of data received or sent via this interface, and the percentage of
When all interfaces are displayed, the default gateway is also output, i.e. the address of a
router to which all packages are sent that cannot reach their destination directly via a local
interface.
The default gateway is therefore a piece of data that applies to all interfaces and of which
there is only one instance. However, there is one interface via which it must be possible to
address the default gateway. This is displayed in brackets after the address.
show drives
Syntax:
Authorization level:
"sc show drives" shows the available remote file systems for a particular server. The server
name SERVER can be an NFS server or a "TCU", which represents any USB media that are
connected to a TCU. For details of possible server names and entering a user name (often
required for SMB), see the description of the "sc connect" command.
NCU operating system (IM7)
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
operating system in brackets (ethN or ibnN).
ExternalIP/ExternalNetMask for X130, InternalIP/Internal-NetMask for X120), or
"(default)" if nothing is configured in the basesys.ini, or "DHCP" if the address was
sourced via DHCP.
address of the interface.
(receive e.g. DHCP via this interface).
the case of a client, the server where the IP address comes from is displayed, too. A
DHCP server on X120 can additionally be synchronized on the system network. Then the
information is displayed if this is the active server or if it is in standby mode.
faulty packages.
sc show drives SERVER
none
Configuring the system
2.5 Description of the actions
53
Advertisement
Chapters
Table of Contents
