Action Log - Siemens SINUMERIK 840D sl Commissioning Manual
Basesoftware and operating software
Hide thumbs
Also See for SINUMERIK 840D sl:
- Function manual (2184 pages) ,
- Programming manual (1334 pages) ,
- Diagnostic manual (1054 pages)
Table of Contents
Advertisement
Service and diagnostics
18.8 Action log
18.8
Action log
18.8.1
Setting the action log
In the "Action Log Settings" window you specify whether the operating sequences are to be
logged.
Here, you select which control actions should be logged, so that operator actions and
sequences can be tracked and understood at a later date.
When the action log is active, you can display recorded traces in the system data using the
following files:
● "actual_actionlog.com", actual action log report
● "actual_crashlog.com", crashlog backup
Data that can be logged
Logging on
Alarm status change
Keyboard actions
Channel status change
Window switchover
Writing NCK/PLC data
File access
Function calls in the NCK
(PI service)
Curr. program status
340
Logging is activated or deactivated.
Incoming and outgoing alarms are logged.
All actions on the operator panel front and on an external
keyboard are logged.
NC/PLC states are logged via the information channel status. If
this information can be obtained in a timely manner, in many
cases these states can be used to verify the operation of the
machine control panel.
The form and dialog names (assigned by the programmer) are
logged each time a window is opened or closed.
The writing of NCK and PLC variables is logged.
Copying to the NC is logged.
Some program calls, for example, ASUB, are logged.
Additional information for particular events is activated. For
important alarms that require NC stop, NC start, or NC reset,
actual values and the current block are recorded for example.
The program ascertains which channel and which spindle are
used for the additional information.
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
SINUMERIK Operate (IM9)
Advertisement
Chapters
Table of Contents
