Measuring Workpieces In Milling - Siemens SINUMERIK 840D sl Commissioning Manual
Basesoftware and operating software
Hide thumbs
Also See for SINUMERIK 840D sl:
- Function manual (2184 pages) ,
- Programming manual (1334 pages) ,
- Diagnostic manual (1054 pages)
Table of Contents
Advertisement
Configuring cycles
22.8 Measuring cycles and functions
22.8.3.1
Measuring workpieces in milling
Measuring in the "Machine" operating area can be appropriately adapted to the specific
requirements using the following channel-specific general machine data and channel-specific
cycle setting data.
General configuration machine data
SD55630 $SCS_MEA_FEED_MEASURE
300
Note
Measuring feedrate for workpiece measuring
All measuring cycles use the value saved in SD54611 as the measuring feedrate value
following calibration of the workpiece probe. A different measuring feedrate can be assigned
for each calibration field [n].
When calibrating the probe, either the measuring feedrate from SD55630
$SCS_MEA_FEED_MEASURE is used, or the measuring feedrate can be overwritten in the
input screen when calibrating. To do this, SD54760 $SNS_MEA_FUNCTION_MASK_PIECE
bit 4 must be set to 1.
MD52207 $MCS_AXIS_USAGE_ATTRIB[n]
Bit 6
MD51751 $MNS_J_MEA_M_DIST_MANUELL
= 10
MD51757 $MNS_J_MEA_COLL_MONIT_FEED
= 1000
540
Default value
Request rotary axis as offset target for measuring.
= 0 Default value
=1 Rotary axis is displayed as correction target in the "Measuring in JOG" window.
Default value
Default value
Calibrating the measuring feedrate for
the workpiece probe and measuring the
workpiece
Attributes of the axes
[n] channel axis number
Measuring path in mm, before and after the
measuring point.
Position feedrate in mm/min, in the working
plane for active collision monitoring.
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
SINUMERIK Operate (IM9)
Advertisement
Chapters
Table of Contents
