"Global" programming
Syntax:
Description:
Parameters:
Example
CHANGE()
EXIT
END_CHANGE
6.2.2
FOCUS
Description
The FOCUS method is executed if the focus (cursor) is positioned on another field in the
dialog.
The FOCUS method must not be initiated as a result of a navigation event. The cursor
position may only be changed in softkey PRESS blocks, CHANGE blocks. The response of
cursor movements is predefined.
Note
Within the FOCUS block, it is not possible to select a different variable, nor can a new dialog
be loaded.
Programming
Syntax:
Description:
Parameters:
SINUMERIK Integrate Run MyScreens (BE2)
Programming Manual, 03/2013, 6FC5397-1DP40-3BA1
CHANGE()
...
END_CHANGE
Changes any variable value
- None -
; If any of the variable values change, the
dialog will be terminated.
FOCUS
...
END_FOCUS
Positions the cursor
- None -
Programming commands
6.2 Methods
81