No Duplex; Lldp - Siemens SIMATIC NET Configuration Manual
Industrial wireless lan to ieee 802.11n command line interface
Hide thumbs
Also See for SIMATIC NET:
- System manual (372 pages) ,
- Manual (300 pages) ,
- Operating instructions manual (90 pages)
Table of Contents
Advertisement
Configuration
3.1 System
3.1.10.4
no duplex
Description
With this command, you reset the duplex mode of an interface to the default value.
The default value is
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
no duplex
Result
The duplex mode of the Interface is reset to the default value.
Further notes
You configure the duplex mode of the interface with the
3.1.10.5
lldp
Description
With this command, you enable the sending and receipt of LLDP packets on the interface.
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
lldp{transmit|receive}
62
.
full
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
command.
duplex
Configuration Manual, 10/2015, C79000-G8976-C351-05
Hide quick links:
Advertisement
Table of Contents
