5.2
NTP client
This section describes commands relevant for configuration of the NTP client.
5.2.1
The "show" commands
This section describes commands with which you display various settings.
With the command
configuration mode.
To do this, you replace
Example
do show cli-console-timeout
5.2.1.1
show ntp info
Description
This command shows the current settings for the Network Time Protocol (NTP).
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call the command without parameters:
show ntp info
Result
The current NTP settings are displayed.
5.2.2
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
Privileged EXEC mode again.
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
do [command]
[command]
or
cli#
you can execute the "show" commands in every
with the "show" command that you want to execute.
configure terminal
or
end
exit
5.2 NTP client
command to change to this mode.
command and are then in the
System time
119