Show Wlan Client (Client) - Siemens SIMATIC NET Configuration Manual
Industrial wireless lan to ieee 802.11n command line interface
Hide thumbs
Also See for SIMATIC NET:
- System manual (372 pages) ,
- Manual (300 pages) ,
- Operating instructions manual (90 pages)
Table of Contents
Advertisement
Syntax
Call up the command with the following parameters:
show wlan basic <wlan 0/X>
The parameter has the following meaning:
Parameter
wlan 0/X
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
Result
The following WLAN settings are displayed:
● Admin status (whether the interface is switched on or off)
● Frequency band
● WLAN mode
● DFS (802.11h)
● Outdoor Mode
● Max Tx Power
● TX power check: Indicates whether the current WLAN settings of the selected country
violate the permitted transmit power restrictions.
6.1.1.8
show wlan client (Client)
Description
This command shows the client configuration of the SCALANCE W700 device, for example
how the MAC address is assigned to the client.
Note
This command is only available in the client mode.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
Description
WLAN interface
or
cli#
Range of values / note
Enter a valid interface.
Network structures
6.1 WLAN
137
Hide quick links:
Advertisement
Table of Contents
