Show Wlan Client-List-Vap (Access Point) - Siemens SIMATIC NET Configuration Manual
Industrial wireless lan to ieee 802.11n command line interface
Hide thumbs
Also See for SIMATIC NET:
- System manual (372 pages) ,
- Manual (300 pages) ,
- Operating instructions manual (90 pages)
Table of Contents
Advertisement
Syntax
Call up the command with the following parameters:
show wlan client-list [wlan 0/X [{mac <macaddr> | sys <sysname> | AID}]]
The parameter has the following meaning:
Parameter
wlan 0/X
mac
macaddr
sys
sysname
AID
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
Result
The table with the logged-on clients is displayed.
6.1.1.10
show wlan client-list-vap (access point)
Description
This command shows the VAP interface via which the clients are logged on to the access
point in the form of a table.
Note
The command is available only in access point mode.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show wlan client-list-vap vapX 0/Y [AID]
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
Description
WLAN interface
Keyword for the MAC address of the client
MAC address
Keyword for the system name of the client
System name
Connection ID of the client.
or
cli#
Network structures
6.1 WLAN
Range of values / note
Enter a valid interface.
-
aa:bb:cc:dd:ee:ff
-
-
139
Hide quick links:
Advertisement
Table of Contents
