Siemens SIMATIC NET Configuration Manual page 130
Industrial wireless lan to ieee 802.11n command line interface
Hide thumbs
Also See for SIMATIC NET:
- System manual (372 pages) ,
- Manual (300 pages) ,
- Operating instructions manual (90 pages)
Table of Contents
Advertisement
System time
5.3 SNTP client
Requirement
● The SNTP client is activated.
● You are in the SNTP Configuration mode.
The command prompt is:
cli(config-sntp)#
Syntax
Call up the command with the following parameters:
sntp client addressing-mode{unicast|broadcast}
The parameters have the following meaning:
Parameter
unicast
broadcast
Result
The addressing mode of the SNTP client is configured.
Further notes
You display this setting and other information with the
You display the settings for the unicast mode with the
command.
You display the settings for the broadcast mode with the
command.
130
Description
configures the SNTP client in unicast
mode
configures the SNTP client in broad-
cast mode
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Range of values / note
Default: unicast enabled
-
show sntp status
show sntp unicast-mode status
show sntp broadcast-mode status
Configuration Manual, 10/2015, C79000-G8976-C351-05
command.
Hide quick links:
Advertisement
Table of Contents
