Nat Interface (Client) - Siemens SIMATIC NET Configuration Manual
Industrial wireless lan to ieee 802.11n command line interface
Hide thumbs
Also See for SIMATIC NET:
- System manual (372 pages) ,
- Manual (300 pages) ,
- Operating instructions manual (90 pages)
Table of Contents
Advertisement
Further notes
You show the NAT configuration and the translation list with the
See also
show nat (Client) (Page 371)
9.1.3.4
nat interface (Client)
Note
This command is only available in the client mode.
Description
With this command, you enable NAT for the Ethernet interface.
Requirement
You are now in the NAT Configuration mode.
The command prompt is as follows:
cli(config-nat)#
● "Own" is set for "MAC Mode".
Syntax
Call up the command with the following parameters:
nat interface <interface-type><interface-id>}
The parameters have the following meaning:
Parameter
interface-type
interface-id
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
Result
NAT is activated for the Ethernet interface.
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
Description
Type or speed of the interface
Module no. and port no. of the interface
Layer 3 functions
9.1 NAT
command.
show nat
Range of values / note
Enter a valid interface.
377
Hide quick links:
Advertisement
Table of Contents
