Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no snmp notify <NotifyName>
The parameter has the following meaning:
Parameter
NotifyName
Result
The details of the SNMP notifications are deleted.
Further notes
You change the details of an SNMP group with the
You display the configured SNMP notifications with the
You display the configured SNMP target addresses with the
command.
7.4.2.14
snmp targetaddr
Description
With this command, you configure the SNMP target address.
Requirement
● The SNMP target parameters are configured.
You are in the Global configuration mode.
The command prompt is:
cli(config)#
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
Description
Name of the notification
Range of values / note
max. 32 characters
command.
snmp notify
command.
show snmp notif
show snmp targetaddr
Network protocols
7.4 SNMP
343