Wlan Overlap-Ap Aging (Access Point) - Siemens SIMATIC NET Configuration Manual
Industrial wireless lan to ieee 802.11n command line interface
Hide thumbs
Also See for SIMATIC NET:
- System manual (372 pages) ,
- Manual (300 pages) ,
- Operating instructions manual (90 pages)
Table of Contents
Advertisement
Network structures
6.1 WLAN
Result
The indoor mode is enabled or the outdoor mode is disabled.
Further notes
You display the setting with the
You enable the outdoor mode with the
See also
wlan outdoor (Page 203)
6.1.5.54
wlan overlap-ap aging (access point)
Description
With this command, you configure the aging time for the list of overlapping access points. If
an access point is inactive for longer than the set time, it is removed from the list.
Note
This command is available only in access point mode.
Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call up the command with the following parameters:
wlan overlap-ap aging <min(1-7200)>
The parameter has the following meaning:
Parameters
min
Result
The aging time is specified.
Further notes
You display the setting with the
204
show wlan basic <wlan 0/X>
wlan outdoor
Description
Time in minutes (min)
show wlan advanced <wlan 0/X>
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
command.
command.
Range of values / note
1...7200
Default: 120
command.
Configuration Manual, 10/2015, C79000-G8976-C351-05
Hide quick links:
Advertisement
Table of Contents
