Network structures
6.2 VLAN
If you do not select any parameter from the parameter list, the entries are displayed for all
available interfaces.
Result
The entries are displayed.
6.2.1.2
show mac-address-table
Description
This command shows the table with the static and dynamic unicast MAC addresses and
multicast MAC addresses.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show mac-address-table [vlan<vlan-range>][address<aa:aa:aa:aa:aa:aa>]
The parameters have the following meaning:
Parameter
vlan
vlan-range
address
aa:aa:aa:aa:aa:aa
interface
interface-type
interface-id
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
If you do not select any parameter from the parameter list, the entries are displayed for all
available interfaces.
Result
The entries of the MAC addresses table are displayed.
218
or
cli#
[interface <interface-type><interface-id>]
Description
Keyword for a VLAN or VLAN range
Number of the addressed VLAN or
VLAN range
Keyword for a MAC address
MAC address
Keyword for a an interface description
Type or speed of the interface
Module no. and port no. of the interface
Range of values / note
-
1 ... 4094
-
-
-
Enter a valid interface.
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05