No Wlan Dfs Prefer-Configured-Channel - Siemens SIMATIC NET Configuration Manual
Industrial wireless lan to ieee 802.11n command line interface
Hide thumbs
Also See for SIMATIC NET:
- System manual (372 pages) ,
- Manual (300 pages) ,
- Operating instructions manual (90 pages)
Table of Contents
Advertisement
Network structures
6.1 WLAN
Requirement
● DFS is enabled.
● The access point does not select the channel automatically.
● You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call the command without parameter assignment:
wlan dfs prefer-configured-channel
Result
The function is enabled.
Further notes
You display the setting with the
You disable the function with the
setting).
6.1.5.36
no wlan dfs prefer-configured-channel
Description
With this command you disable the access point changing back to the configured channel
automatically after the channel is released again following a blockage.
Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call the command without parameter assignment:
no wlan dfs prefer-configured-channel
Result
The function is disabled.
188
show wlan advanced <wlan 0/X>
no wlan dfs prefer-configured-channel
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
command.
command (default
Hide quick links:
Advertisement
Table of Contents
