No Option - Siemens SIMATIC NET Configuration Manual
Industrial wireless lan to ieee 802.11n command line interface
Hide thumbs
Also See for SIMATIC NET:
- System manual (372 pages) ,
- Manual (300 pages) ,
- Operating instructions manual (90 pages)
Table of Contents
Advertisement
Network protocols
7.3 DHCP server
7.3.3.6
no option
Note
The command is only available when the following requirements are met:
• SCALANCE W722-1 RJ45 (article no.: 6GK5722-1FC00-0AA0 and 6GK5722-1FC00-
0AB0 (US version))
• SCALANCE W761-1 RJ45 in access point mode (article number): 6GK5761-1FC00-0AA0
and 6GK5761-1FC00-0AB0 (US version))
• The IPv4 address band is not enabled.
Description
With this command, you delete the DHCP option with the specified number.
Requirement
You are in the DHCPPOOL configuration mode.
The command prompt is as follows:
cli(config-dhcp-pool-<ID>)#
Syntax
Call up the command with the following parameters:
no option <option-code>
The parameter has the following meaning:
Parameter
option-code
Result
The specified DHCP option is deleted.
Further notes
You configure the DHCP option 67 with the
You configure the DHCP options 3, 6 and 66 with the
You configure all other DHCP options with the
318
Description
Code of the DHCP option
option value-string
option value-hex
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Range of values / note
Enter a valid number.
command.
command.
option
command.
Configuration Manual, 10/2015, C79000-G8976-C351-05
Hide quick links:
Advertisement
Table of Contents
