Siemens SINUMERIK 840D sl Function Manual page 473
Hide thumbs
Also See for SINUMERIK 840D sl:
- Function manual (1726 pages) ,
- Programming manual (1334 pages) ,
- Commissioning manual (1102 pages)
Table of Contents
Advertisement
2.5.5
System variable for status of pulse enable
Application
For all applications that must quickly react to pulse enabling, the status of the pulse enable is
imaged to a new system variable in order to accelerate the braking signal.
This system variable is preferably evaluated in synchronized actions. Using the synchronized
action, either a direct output to an NCK output can be carried out or a faster transfer to the
PLC.
Functionality
Since 611D digital drives have no integrated braking signal, the brakes are normally
controlled from the PLC. The brake can be closed again by deleting the pulse enable in the
PLC.
If the pulse enable is deleted due to external events (611D interface, terminal 663 to the
PLC) or due to drive or axis errors, the PLC can close the brake only with a delay, since the
transport of the pulse enable signal via servo and interpolator requires 2 to 3 interpolator
cycle clocks. In the worst case, the PLC needs another two PLC cycles. With hanging axes
and linear motors, this is often slow.
System variable for enabling the drive power
Since the function must be available for all kinds of drives in the same form (also for non-
electrical drives), the variable is given the name "Drive power enable".
Description
Status of the power enable (pulse enable) of a
machine axis
Predefined range of values:
FALSE: no power enable
TRUE: power enable exists
Activation
The variable is predefined and can be used at any time acc. to the data type BOOL with
FALSE or TRUE. While communication with the drive is not yet established, the value 0
(FALSE) is supplied.
The synchronized actions, in which the variable is evaluated, should preferably be carried
out as soon as the control powers up, e.g., by starting an ASUB from the PLC. To make sure
that the synchronized actions remain continuously active and are not affected by the mode
change, we recommend that they are programmed as "static synchronized actions" (using
IDS as the vocabulary word).
Basic logic functions: Velocities, Setpoint/Actual Value Systems, Closed-Loop Control (G2)
Function Manual, 11/2006, 6FC5397-0BP10-2BA0
2.5 Optimization of the control
NCK variable
$VA_DPE[machine axis]
Detailed description
85
- Quick Links:
- Alarm Behavior
- Programming
- Machine Data
Hide quick links:
Advertisement
Chapters
Table of Contents
