Table of Contents
Advertisement
In this section, describes the service menu (SERVICE menu) in the setup menu displayed on the view-
finder. For other menus, refer to Section 3 of the Installation and Maintenance Manual.
5-1. Setup Menu
The setup menu is used for selecting various setting values, items displayed on the viewfinder screen, the
method of displaying, and adjustments. The menu is displayed on the viewfinder screen. The menu can
also be displayed by connecting an external monitor to the TEST OUT connector.
Normally, SERVICE menu will not be displayed in the setup menu, but this SERVICE menu can be
displayed by setting the switches (S100-1 to S100-4) on the AT-130 board.
Structure of Setup Menu
The setup menu is composed of the following menus.
. USER menu (This menu is displayed only when the ROM version on the AT board of
the unit is Ver 1.30 or higher.)
. USER MENU CUSTOMIZE menu (This menu is displayed only when the ROM
version on the AT board of the unit is Ver 1.30 or higher.)
. OPERATION menu
. PAINT menu
. MAINTENANCE menu
. FILE menu
. DIAGNOSIS menu
. SERVICE menu (This menu is not displayed at the factory setting state.)
n
Beside above menus, the TOP menu is provided for indicating the whole configuration of the menu items.
Selecting the Menu
The menus to be displayed on the viewfinder screen can be selected by the switches (S100-1 to S100-4)
on the AT-130 board. At the factory setting state, the menu is set to display from OPERATION menu to
DIAGNOSIS menu.
( ) : Shows the factory setting
Switch Settings
S100-1 S100-2 S100-3
S100-4
(OFF)
(OFF)
(OFF)
(OFF)
ON
OFF
OFF
OFF
OFF
ON
OFF
OFF
ON
ON
OFF
OFF
OFF
OFF
ON
OFF
ON
ON
ON
ON
HDC-900/950 MM
Section 5
SERVICE Menu
Setup Menu
USER
USER MENU OPERATION
CUSTOMIZE
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
PAINT
MAINTENANCE
FILE
Yes
Yes
Yes
Yes
Yes
No
Yes
No
No
No
No
No
No
No
No
Yes
Yes
Yes
DIAGNOSIS SERVICE
Yes
No
Yes
No
Yes
No
Yes
No
No
No
Yes
Yes
5-1 (E)
Advertisement
Table of Contents
