Table of Contents
Advertisement
4. Remove the two screws, and remove the VF DISP
switch assembly.
Precision
P2.6 x 5
5. Remove the two screws and three packings, and
remove the SW-1016 board. Desolder the switch to be
replaced.
Packings
6. Install the new switches in the reverse order of steps 1
to 5.
HDC-900/950 MM
VF DISP switch
assembly
SW-1016 board
M2 x 4.5
3-6. Replacing the VF DISP Switches (SW-1016 Board)
3-7. Replacing the CCU Connector
n
Optical cables used in the unit are very fragile. So do not
bend or yank in handling. This causes a break in the cable.
1. Remove the outside panel. (Refer to Section 1-4 of the
Installation and Maintenance Manual.)
2. Remove the four screws, and remove the heat sink
assembly.
3-7. Replacing the CCU Connector
Heat sink assembly
B2.6 x 6
3-11 (E)
Advertisement
Table of Contents
