Table of Contents
Advertisement
5. Remove the three screws, and remove the RX holder.
PS2.6 x 4
RX holder
6. Remove the three screws, and remove the RX-28
board.
RX holder
Precision
P2.6 x 2.8
Precision
P2 x 3.5
7. Install the new RX-28 board in the reverse order of
steps 1 to 6.
HDC-900/950 MM
[Notes|at|installation]
. Before connecting the connection connector, clean the
white optical contact at the tip of connector with alcohol.
. Align the protrusion of the connector with the notch of
the interconnection connector in connecting.
Optical contact (white) Interconnection connector
. Refer to the figure and keep the extra optical cable
(slacked part) in the fiber box.
RX-28 board
Protrusion
Notch
(white)
Optical cable (white)
winding direction
3-14. Replacing the Boards
(yellow)
Optical cable (white)
3-19 (E)
Advertisement
Table of Contents
