Table of Contents
Advertisement
3-1. Replacing the CCD Unit
3-2. Replacing the Filter Disk Unit
5. Remove the three screws, and remove the transporta-
tion holder from the CCD unit for repair part HKC-
C900R (optional).
Transportation holder
P3 x 6
P3 x 6
P3 x 6
6. Attach the new CCD unit in the reverse order of steps
1 to 4.
3-2 (E)
3-2. Replacing the Filter Disk Unit
3-2-1. Filter Disk Unit
n
The following replacement procedures of the filter disk
unit are described on the HDC-950/930 base. When the
filter disk unit of the HKC-T950 is replaced, remove the
right side panel referring to Section 3-15-5 "IF-845
Board", and then perform the following step 2 and later.
1. Remove the inside panel. (Refer to Section 1-4 of the
CCD unit
Installation and Maintenance Manual.)
2. Disconnect the connector of filter disk unit, loosen the
two fixing screws of the filter disk unit.
3. Pulling the filter knob (CC) to the arrow direction,
draw out the filter disk unit.
Filter knob
(CC)
Filter disk unit
Fixing screws of
the filter disk unit
(with stopper)
Connector
Filter disk unit
HDC-900/950 MM
Advertisement
Table of Contents
