Table of Contents
Advertisement
[Notes|at|installation]
. Before connecting the connection connector, clean the
white optical contact at the tip of connector with alcohol.
. Align the protrusion of the connector with the notch of
the interconnection connector in connecting.
Optical contact
(white)
. Refer to the figure and keep the extra optical cable
(slacked part) in the fiber box.
Optical cable (blue)
HDC-900/950 MM
2-6-2. RX-28 Board
m
. Every electrical part mounted on the RX-28 board
. Optical cables used in the unit are very fragile. So do not
1. Perform steps 1 to 4 of Section 2-6-1.
2. Disconnect the harness from the connector CN2 of the
Protrusion
Notch
Optical cable (blue)
winding direction
cannot be replaced. If there is any defective part, replace
the board itself.
bend or yank in handling. This causes a break in the
cable.
RX-28 board, and disconnect the coaxial cable from
the connector CN1.
Coaxial cable
CN1
CN2
2-6. Replacing the Boards
2-9 (E)
Advertisement
Table of Contents
