Table of Contents
Advertisement
3-5. Replacing the Side Switches (SW-1014 Board)
3-6. Replacing the VF DISP Switches (SW-1016 Board)
5. Remove the two screws and two blind plates, and
remove the SW-1014 board. Desolder the switch to be
replaced.
Precision
P2.6 x 5
6. Install the new switches in the reverse order of steps 1
to 5.
3-10 (E)
SW-1014 board
Blind plates
3-6. Replacing the VF DISP Switches
(SW-1016 Board)
1. Remove the front assembly. (Refer to steps 1 and 2 of
Section 3-1)
n
If the HKC-T950 is installed, remove the cable adaptor
first referring to Section 3-15-1.
2. Disconnect the connectors (CN1 and CN2) of
SW-1016 board.
3. Loosen the four screws, and remove the handle
assembly.
B3 x 10
(with stopper)
Handle assembly
B3 x 10
(with stopper)
SW-1016
board
CN1
CN2
HDC-900/950 MM
Advertisement
Table of Contents
