Table of Contents
Advertisement
3-14. Replacing the Boards
3-15. Replacing the Components of HKC-T950
[Notes|at|installation]
. Before connecting the connection connector, clean the
white optical contact at the tip of connector with alcohol.
. Align the protrusion of the connector with the notch of
the interconnection connector in connecting.
Notch
(blue,white)
Interconnection
connector
3-24 (E)
Protrusion
(yellow)
Optical contact (white)
3-15. Replacing the Components of
HKC-T950
The HKC-T950 consists of the CCD block adaptor and
cable adaptor.
In the actual operation, the CCD block is installed in the
CCD block adaptor, and the cable adaptor is installed in
the place where the CCD block of the HDC-950/930 had
been installed.
Following replacing procedures are described assuming the
actual operation.
3-15-1. Removing the Cable Adaptor
1. Remove all the cables connected to the cable adaptor.
2. Remove the inside panel and outside panel of the
HDC-950/930. (Refer to Section 1-4 of the installation
and maintenance manual.)
3. Loosen the four screws, and remove the cable adaptor
from the camera.
Outside panel
Screws
(with stopper)
Screws
Cable adaptor
(with stopper)
Inside panel
HDC-900/950 MM
Advertisement
Table of Contents
