Table of Contents
Advertisement
3-15-2. Removing/Installing the Handle
Assembly
n
If using the CCD block adaptor with the handle assembly
detached, it is recommended to attach the chassis cover.
1. Loosen the four screws of the CCD block adaptor, and
remove the handle assembly.
2. Disconnect the connectors (CN3, CN4) of the AT-146
board.
3. Disconnect the connectors (CN1, CN2) of the IF-845
board.
4. Install the handle assembly in the reverse order of
steps 1 to 3 of removal.
Screws
(with stopper)
Handle assembly
CN1
CN2
CN4
CN3
HDC-900/950 MM
IF-845 board
AT-146 board
CCD block adaptor
3-15. Replacing the Components of HKC-T950
3-15-3. Replacing the Lens Cable
Tool: Installation and removal tool (for bushing)
(Sony Part number : J-6470-280-A)
(If it is not available, use a pair of pliers or a similar
item.)
Removing
1. Remove the cable adaptor from the camera. (Refer to
Section 3-15-1.)
2. Remove the six screws, and remove the shield case.
3. Disconnect the connector (CN2) of the AT-147 board.
4. Remove one screw, and remove the GND terminal.
5. Remove the two screws, and remove the lens cable
bracket.
6. Pinch the cord bushing by the tool as shown in the
figure and pull out the cord bushing in the direction of
the arrow.
Shield case
Lens cable
Screws
GND terminal
Screw
Screw
CN2
Cable bushing
Lens cable bracket
Lens cable
Installation and removal tool
(for bushing)
Cable bushing
Lens cable bracket
Screws
Screw
Screws
AT-147 board
3-25 (E)
Advertisement
Table of Contents
