Table of Contents
Advertisement
3-9. Replacing the PROMPTER Connector
3-10. Replacing the VF Connector
3-9. Replacing the PROMPTER
Connector
1. Remove the CN-1951 board. (Refer to steps 1 to 4 of
Section 3-8.)
2. Remove the two screws, and remove the PROMPTER
connector assembly.
PROMPTER connector
3. Install the new PROMPTER connector in the reverse
order of steps 1 and 2.
3-14 (E)
3-10. Replacing the VF Connector
1. Remove the front assembly. (Refer to steps 1 and 2 of
Section 3-1.)
n
If the HKC-T950 is installed, remove the cable adaptor
first referring to Section 3-15-1.
2. Pull out the plug-in boards (RE, AU, AT, SG, DAP,
DAD, VDA, DPR, VA) along the groove of the board
rail and remove. (Refer to steps 1 and 2 of Section 3-1.)
3. Disconnect the connector (CN14) of MB-882 board.
4. Remove the two screws, and remove the VF connector
and nut plate.
Precision
K2.6 x 4
5. Install the new VF connector in the reverse order of
steps 1 to 4.
[Note|at|installation]
Regarding harness (VF), follow with the mount procedures
step 4. Fix the gray wire-bundle with clamper while other
wire-bundles will be clamped with binding tie.
CN14 (VF)
MB-882 board
Precision
P2.6 x 8
VF connector
Harness (VF)
Nut plate
Clamper
Gray wire-bundle
HDC-900/950 MM
Advertisement
Table of Contents
