Table of Contents
Advertisement
3-4-3. Fan for HKC-T950
n
When replacing the fan, replace the cushion pasted to the
fan too.
Cushion : 3-690-767-0X
1. Remove the separate plate (2) block. (Refer to steps 1
to 7 of Section 3-15-5 "IF-845 Board".)
2. Disconnect the connector (CN15) of the IF-845 board.
3. Remove the two damper screws, and remove the fan.
Fan harness
Damper screw
Separate plate (1)
4. Paste a new cushion to a new fan.
(1) How to paste the Cushion
Cushion
(2) Pasting position of Cushion
+ 0.5
2 mm
_ 0
5. Install the new fan in the reverse order of steps 1 to 3.
[Note|at|installation]
When installing the fan to the separate plate (1), be sure to
install the fan so that the label faces downward as shown in
the figure.
HDC-900/950 MM
Fan
Damper screw
Label faces
downward
Start to paste from here
Cut the surplus cushion
Fan
Label
3-5. Replacing the Side Switches (SW-1014 Board)
3-5. Replacing the Side Switches
(SW-1014 Board)
1. Remove the front fan assembly.
(Refer to Section 3-4-2.)
2. Open the side switch covers, then removes the two
screws, and remove the side switch panel assembly.
Side switch cover
3. Disconnect the connectors (CN1, CN2, and CN3) of
SW-1014 board.
4. Remove the two screws, and remove the side switch
block.
CN1
CN2
3-4. Replacing the Fan
Precision P2.6 x 5
Side switch
panel assembly
CN3
Precision
P2.6 x 5
Side switch block
3-9 (E)
Advertisement
Table of Contents
