Table of Contents
Advertisement
3-15. Replacing the Components of HKC-T950
3-15-7. CAM BODY Connector
1. Remove the separate plate (2) block. (Refer to steps 1
to 7 of Section 3-15-5 "IF-845 Board".)
2. Remove the four screws, and remove the CAM BODY
connector.
Red mark
CAM BODY
connector
Screws
3. Install the new CAM BODY connector so that the red
mark on it faces upwards.
n
Apply locking compound to the fixing screws.
4. Install the separate plate (2) block in the reverse order
of removal.
3-30 (E)
3-15-8. VIDEO OUT/LENS Connector
1. Remove the separate plate (2) block. (Refer to steps 1
to 7 of Section 3-15-5 "IF-845 Board".)
2. Remove the nut of the connector to be replaced.
GND terminal
VIDEO OUT
Connector
Nut
Locking
compound
LENS Connector
Locking
compound
Nut
3. Install the new connector in the reverse order of steps
1 and 2.
m
. Align the position of GND terminal for the VIDEO
OUT connector as shown in the figure, and the
tighten the nut.
. After tightening the nut, apply a locking compound
to the position shown in the figure.
HDC-900/950 MM
Advertisement
Table of Contents
