Table of Contents
Advertisement
Replacement of Main Parts (HDC-950/930, HKC-T950)
3-1. Replacing the CCD Unit
m
. Never remove or install the CCD unit with the power
turned on. Because touching internal harness to the
cabinet or other printed circuit boards during replace-
ment causes shorts or electric hazards.
Prior to replacement, be sure to disconnect the optical
cable or the cable connected at the DC IN connector in
addition to turning off power switch.
. The following replacement procedures of the CCD unit
are described on the HDC-950/930 base. When the CCD
unit of the HKC-T950 is replaced, remove the front
assembly referring to Section 3-15-5 "IF-845 Board",
and then perform the following step 3 and later.
1. Remove the inside panel and outside panel. (Refer to
Section 1-4 of the Installation and Maintenance
Manual.)
2. Loosen the four screws of front assembly, and remove
the front assembly.
B3 x 10
(with stopper)
B3 x 10
(with stopper)
Front assembly
HDC-900/950 MM
Section 3
3. Remove the four hexagon-socket bolts, remove the
four spring washers, and remove the front panel
assembly.
Spring
washers
Hexagon-socket bolts
(3 x 8)
4. Disconnect the harness from the connector of CCD
unit, loosen the two fixing screws of the filter disk
unit, and remove the filter disk unit.
Connector
Front panel assembly
Fixing screw of the filter
disk unit (with stopper)
Filter disk unit
Fixing screw of the filter
disk unit (with stopper)
3-1 (E)
Advertisement
Table of Contents
