Table of Contents
Advertisement
List of Menus
Item number Category
T048
status
T049
status
T050
status
T051
status
Item
Arguments
rtp_seq_error
–
rtp_rx_fec_mode
–
ts_corrected
–
ts_uncorrected
–
Function
In asi_to_sdi/asi_to_sdti-cp/tx-rx/tx-rx (cm)
mode, outputs the number of RTP
sequence discontinuities detected in the
most recent one-second interval.
In sdi_to_asi/sdti-cp_to_asi mode, outputs
"--------" to indicate that this is invalid.
The maximum output value is "255." That
is to say, if there are 255 or more RTP
packet receiving errors are in a second, the
output is "255."
Note that when the MSBA-20IP board is
not installed, "RTP option is not mounted"
is output.
In asi_to_sdi/asi_to_sdti-cp/tx-rx/tx-rx (cm)
mode, indicates whether error correction is
enabled or disabled (fec_mode) for the
RTP packets currently being received.
In sdi_to_asi/sdti-cp_to_asi mode, outputs
"--------" to indicate that this is invalid.
If the stream has error correction, outputs
"on", and if the stream has no error
correction, outputs "off."
When no RTP packets are received, "-------
-" is output.
Note that when the MSBA-20IP board is
not installed, "RTP option is not mounted"
is output.
In asi_to_sdi/asi_to_sdti-cp/tx-rx/tx-rx (cm)
mode, when fec_mode is "on," outputs the
number of TS packets in the most recent
one-second interval amended as a result of
applying FEC correction.
When fec_mode is "off," or in asi_to_sdi/
asi_to_sdti-cp mode, outputs "--------" to
indicate that this is invalid.
The maximum output value is "255." That
is to say, if FEC correction applies to 255
or more TS packets in a second, the output
is "255."
Note that when the MSBA-20IP board is
not installed, "RTP option is not mounted"
is output.
In asi_to_sdi/asi_to_sdti-cp/tx-rx/tx-rx (cm)
mode, when fec_mode is "on," outputs the
number of TS packets the most recent
one-second interval for which a correction
by FEC was not possible.
When fec_mode is "off," or in sdi_to_asi/
sdti-cp_to_asi mode, outputs "--------" to
indicate that this is invalid.
The maximum output value is "255." That
is to say, if 255 or more TS packets could
not be corrected in a second, the output is
"255."
Note that when the MSBA-20IP board is
not installed, "RTP option is not mounted"
is output.
82
Advertisement
Table of Contents
