Table of Contents
Advertisement
List of Menus
In tx-rx mode
(
)
Item number Category
E022**
link_mng (Rx)
E023**
link_mng (Rx)
E024**
link_mng (Rx)
link_mng (Tx/Rx) tos_field
E031**
E998**
link_mng
E999**
link_mng
–**
link_mng
Item
Arguments
rtp_rx_ip
000 to 255 .
000 to 255 .
000 to 255 .
000 to 255
rtp_rx_port
50000 to 65534
buffer_depth
0 to 100 to 2000
00 to ff
cancel
–
init
–
list
–
Function
Sets the source IP address for MPEG
stream input through MSBA-20IP.
If set to 255.255.255.255 data will be
received regardless of the MPEG stream
input source IP address. However, to
receive multicasts, set in the range4.0.0.0
to 239.255.255.255.
Sets the UDP port No. which should be
obtained as an MPEG streaming data
through the MSBA-20IP. The port No. can
only be set to an even number. The RTCP
port No. is the setting value plus one.
Specifies the MSBA-20IP receiving buffer
depth.
The range of settings is from 0 to 2000 ms
(in 1 ms increments).
Note
Normally use the default setting of "100."
The receiving buffer depth range ensuring
a correct operation depends on the setting
in "C061:ts_rate", "C165:rtp_tx_fec_mode"
and "C166:rtp_tx_format" on the
transmitting side, so care is required when
changing the settings.
For details, refer to the Maintenance
Manual.
Specifies the value (8 bits) of the Tos field
(Diff serve field) of IP packets output by the
MSBA-20IP.
Cancels a link_mng change before
execution.
Returns link_mng items to their factory
default settings.
Displays the list set in link_mng.
This is a special-purpose command for
RS232C/telnet operation.
65
Advertisement
Table of Contents
