Table of Contents
Advertisement
List of Menus
(In sdi_to_asi mode)
Item number Category
C061
setup
C062
setup
C063
setup
C064
setup
C065
setup
C066
setup
C067
setup
C068
setup
C069
setup
C070
setup
C071
setup
C072
setup
C073
setup
C074*
setup
C075
setup
C076
setup
C111
setup
C112*
setup
C113
setup
Item
Arguments
ts_rate
auto
manual
3.000 to 8.448 to 68.000 1 kbps. If a certain degree of error occurs,
tx_program_no
00001 to 00200 to 65535 Specifies the program number declared in
video_pid
0x0010 to 00ff to 1ffe
mpeg_ch12_pid
0x0010 to 0101 to 1ffe
mpeg_ch34_pid
0x0010 to 0102 to 1ffe
lpcm_pid
0x0010 to 0100 to 1ffe
pat_version
0 to 31
pat_interval
1 to 33 to 100
pmt_version
0 to 31
pmt_interval
1 to 33 to 100
pcr_pid
0x0010 to 00fe to 1ffe
pcr_interval
1 to 33 to 100
program_map_pid
0x0010 to 00c8 to 1ffe
network_pid
0x0010 to 0064 to 1ffe
tx_packet_size
188
204
tx_asi_mode
packet
burst
pri_pid_base
0x0010 to 00c0 to 1ff7
tx_umid
off
on
tx_line_data1
off
on
Function
The TS rate is calculated automatically. An
'A' appears after the numeric value.
The TS rate can be specified in units of
this is controlled to be below the setting
value.
Argument unit: Mbps
Note
When the MSBA-20IP is installed, keep
ts_rate within 35.000 Mbps.
PAT.
Specifies the video PID.
Specifies the PID for MPEG audio
channels 1 and 2.
Specifies the PID for MPEG audio
channels 3 and 4.
Specifies the PID for linear PCM audio.
Specifies the PAT version number.
Sets the PAT generation interval.
Unit: 1 ms
Specifies the PMT version number.
Sets the PMT generation interval.
Unit: 1 ms
Specifies the PID for PCR.
Sets the PCR generation interval.
Unit: ms
Specifies the PID for PMT.
Specifies the PID for NIT.
Specifies the output TS packet size as 188
bytes.
Specifies the output TS packet size as 204
bytes.
(16 bytes of dummy data inlucluded.)
Note
When an MSBA-20IP board is installed,
the TS packet size for an MPEG stream
output through RTP is fixed at 188 bytes,
irrespective of this setting.
Outputs output TS in packet mode.
Outputs output TS in burst mode.
Specifies the base PID for transferring
private data.
Disables UMID.
Enables UMID. PID is "pri_pid_base" +0
Disables uncompressed line data
processing of 1st line.
Enables uncompressed line data
processing of 1st line.
PID is "pri_pid_base" +1.
52
Advertisement
Table of Contents
