Table of Contents
Advertisement
List of Menus
• In sdti-cp_to_asi mode
Item number Category
E001**
link_mng (Tx)
E002**
link_mng (Tx)
E003**
link_mng (Tx)
E004**
link_mng (Tx)
E005**
link_mng (Tx)
E006**
link_mng (Tx)
E007**
link_mng (Tx)
link_mng (Tx/Rx) tos_field
E031**
E998**
link_mng
E999**
link_mng
–**
link_mng
Item
Arguments
rtp_tx
off
on
rtp_tx_ip
000 to 255.
000 to 255.
000 to 255.
000 to 255
rtp_tx_port
50000 to 65534
rtp_tx_ssrc
0x00000000 to
0x01234567 to 0xffffffff
rtp_tx_fec_mode
off
on
rtp_tx_format
1
2
rtp_tx_cname
MSB-2000
00 to ff
cancel
–
init
–
list
–
Function
Invalidates MPEG streaming output
through the MSBA-20IP.
Validate MPEG streaming output through
the MSBA-20IP. Streaming supports up to
35 Mbps as a TS rate.
Sets the destination IP address for MPEG
streaming output through the MSBA-20IP .
For Multicast transmission, select in the
range 224.0.0.0 to 239.255.255.255.
Sets the UDP port No. for MPEG
streaming output through the MSBA-20IP.
The port No. can only be set to an even
number. The RTCP port No. is the setting
value plus one.
Sets "SSRC" which is member of RTCP.
Default value is 0x01234567.
Invalidates Error collection.
Validate Error collection.
Selects Streaming packet format.
1: 1 TS packet per IPdatagram
2: 6 TS packets per IP datagram
Note
It is recommended to use a setting of "2"
with less overhead. Avoid using both "1"
and "2" on the same network.
The IP transfer bandwidth required for
each TS rate is as follows.
• For a setting of "1" when "C165" is "off":
141% of TS rate
• For a setting of "1" when "C165" is "on":
156% of TS rate
• For a setting of "2" when "C165" is "off":
107% of TS rate
• For a setting of "2" when "C165" is "on":
122% of TS rate
Sets "CNAME" which is member of RTCP.
Default CNAME here is "MSB-2000".
Maximum length is 15 characters.The
characters that can be used are ASCII
codes in the range 0x21 to 0x7d.
Specifies the value (8 bits) of the Tos field
(Diff serve field) of IP packets output by the
MSBA-20IP.
Cancels a link_mng change before
execution.
Returns link_mng items to their factory
default settings.
Displays the list set in link_mng.
This is a special-purpose command for
RS232C/telnet operation.
70
Advertisement
Table of Contents
