Table of Contents
Advertisement
Changing Settings Using Telnet or RS-232C Terminals
Displaying the menu item categories and
menu items
Use the following procedure.
1
On the monitor screen, enter "help" after the
prompt.
A list of menu categories appears after the legend
"Available command list:"
If the category name is followed by two dots (".."),
this indicates that there is more than one menu
item.
2
To display the menu items, enter "help" after the
prompt, and then enter the category name.
The list of menu items appears after the legend
"Setup commands."
(The following figure shows an example display
with "setup" specified as category name when tx-
rx is selected in the "B: mode" menu.)
For more details of the menus, see the List of Menus
(page 36).
Displaying the available settings
Enter "help", the category name, and the item name in
sequence after the prompt.
Checking the current settings of this unit
Enter the category name and item name in sequence
after the prompt.
The current settings appear.
The following figure shows "setup" specified as the
category name and "ref_source" as the item name.
27
Advertisement
Table of Contents
