Table of Contents
Advertisement
List of Menus
•In asi_to_sdti-cp mode
Item number Category
C013
setup
C015*
setup
C051
setup
C052
setup
C081
setup
C101
setup
C102
setup
C141*
setup
C142*
setup
C143*
setup
C144*
setup
C145*
setup
C146*
setup
Item
Arguments
video_rate
30, 35, 40, 45, 50
history
off
part
full
rx_audio_sg
off
1 kHz
silence
lip_sync
–20.000 to +00.000 to
+20.000
fec_mode
off
on
rx_program_no
00001 to 00200 to 65535 Specifies program number for decoding.
rx_packet_size
auto
188
204
rx_udata1
off
on
dst_udata1_port
05000 to 09000 to 65535 Set the UDP port No. for outputting user
dst_udata1_ip
000 to 192 to 255.
000 to 168 to 255.
000 to 001 to 255.
000 to 003 to 255
rx_udata2
off
on
dst_udata2_port
05000 to 09001 to 65535 Sets the UDP port No. for outputting user
dst_udata2_ip
000 to 192 to 255.
000 to 168 to 255.
000 to 001 to 255.
000 to 003 to 255
Function
The video ES bit rate can be specified in
units of 5 Mbps.
The rate control method is All intra CBG
(IMX).
Unit: Mbps
Invalidates history insertion into video ES.
Validates partial history insertion into video
ES.
Validates entire history insertion into video
ES.
Disables the internal test signal generator.
Enables the internal test signal generator
to output a 1 kHz sine wave.
Enables the internal terÙ(signal generator
to output silence.
Carries out lip sync fine adjustment.
Unit: ms
Note
When set to a negative value, note that
operation may not be guaranteed,
depending on the system status.
Invalidates SDTI-CP FEC.
Validates SDTI-CP FEC.
Automatically recognizes input TS packet
size.
Sets input TS packet size to fixed 188 bytes.
Sets input TS packet size to fixed 204 bytes.
Disables user data 1 output from the UDP
port, via the MSBA-20IP.
Enables user data 1 output from the UDP
port, via the MSBA-20IP.
data 1 from the MSBA-20IP.
Sets the destination IP address for output
of user data1 from the MSBA-20IP.
Disables user data 2 output from the UDP
port, via the MSBA-20IP.
Enables user data 2 output from the UDP
port, via the MSBA-20IP.
data 2 from the MSBA-20IP.
Sets the destination IP address for
outputting user data 2 from the MSBA-
20IP.
62
Advertisement
Table of Contents
