Table of Contents
Advertisement
List of Menus
Item number Category
T043
status
T044
status
T045
status
T046
status
T047
status
Item
Arguments
link_duplex
–
ether_rx_packet
–
ether_rx_error
–
rtp_rx_port_no
–
rtp_rx_packet
–
Function
In all modes, when link_status is "up" this
shows the communications mode, as
follows:
When link_status is "up" and there is a full-
duplex connection: "full-duplex"
For a half-duplex connection: "half-duplex"
If link_status is "down," "--------" is output.
Note that when the MSBA-20IP board is
not installed, "RTP option is not mounted"
is output.
In all modes, the number of Ethernet
packets received by the MSBA-20IP in the
most recent one-second interval is shown.
The maximum output value is "65535."
That is to say, if 65535 or more packets
are received in a second, the output is
"65535."
Note that when the MSBA-20IP board is
not installed, "RTP option is not mounted"
is output.
In all modes, out of the Ethernet packets
received by the MSBA-20IP in the most
recent one-second interval, the number of
packets in which an FEC error was
detected is shown.
The maximum output value is "255." That
is to say, if there were 255 or more error
packets in a second, the output is "255."
Note that when the MSBA-20IP board is
not installed, "RTP option is not mounted"
is output.
In asi_to_sdi/asi_to_sdti-cp/tx-rx/tx-rx (cm)
mode, the port No. of the rtp packets
currently being received (udp port) is
output.
In sdi_to_asi/sdti-cp_to_asi mode, outputs
"--------" to indicate that this is invalid.
Permitted values:
50000≤rx_port_no≤65534, and
rx_port_no=0
For rx_port_no=0, to indicate that no rtp
packets are received, "--------" is output.
Note that when the MSBA-20IP board is
not installed, "RTP option is not mounted"
is output.
In asi_to_sdi/asi_to_sdti-cp/tx-rx/tx-rx (cm)
mode, outputs the number of RTP packets
received from the network in the most
recent one-second interval.
In sdi_to_asi/sdti-cp_to_asi mode, outputs
"--------" to indicate that this is invalid.
The maximum output value is "65535."
That is to say, if 65535 or more RTP
packets are input in a second, the output is
"65535."
Note that when the MSBA-20IP board is
not installed, "RTP option is not mounted"
is output.
81
Advertisement
Table of Contents
