177
Description JPDC-Fuse FU1R or FU2R (J1R connector) is blown or SW1R switched OFF.
Possible Cause
•
The specified switch is turned off and FuseDiag is enabled.
•
The specified fuse is blown.
•
The 125 V dc input is not connected.
Solution
•
If the switch is turned off (output is not used), disable the diagnostic by setting FuseDiag to Disable.
•
If the output is used, verify that the switch is turned on.
•
Replace the fuse.
•
Verify the 125 V dc input connections to the terminal board.
•
If the 125 V dc input is not used, this diagnostic alarm can be disabled by setting the InputDiagEnab parameter on the
associated input (DC_125VFdbkMag) to Disabled.
178
Description JPDC-Fuse FU1S or FU2S (J1S connector) is blown or SW1S switched OFF.
Possible Cause
•
The specified switch is turned off and FuseDiag is enabled.
•
The specified fuse is blown.
•
The 125 V dc input is not connected.
Solution
•
If the switch is turned off (output is not used), disable the diagnostic by setting FuseDiag to Disable.
•
If the output is used, verify that the switch is turned on.
•
Replace the fuse.
•
Verify the 125 V dc input connections to the terminal board.
•
If the 125 V dc input is not used, this diagnostic alarm can be disabled by setting the InputDiagEnab parameter on the
associated input (DC_125VFdbkMag) to Disabled.
348
GEH-6855_Vol_II
GEH-6855_Vol_II Mark VIeS Functional Safety Systems Volume II
Public Information