8.5.2.9 TVBAS2B Buffered Outputs
With the TVBAS2B, each channel provides additional outputs other than the standard 37-pin connection. The signal output is
buffered from the signal used by the I/O module to prevent any corruption caused by third-party hardware connected to the
output.
Each channel is output on a BNC connector with 10 kilo-ohms between the buffer out and BNC signal pin and 10 kilo-ohms
isolation between signal low and the control power common, PCOM.
Each channel is also output through a 25-pin or 9-pin connectors JA1, JB1, JC1 and JD1 designed to interface with the Bently
Nevada 3500 monitoring system. The TVBA buffered source impedance is approximately 40 ohms.
The jumper, JPxB where x = 1 through 14 is used to configure the output for either seismic outputs with a -11 V dc bias
voltage added to the velocity signal or positioned to output Proximitor, Velomitor or accelerometer with integrated output
signals.
8.5.2.10 Bently Nevada Buffered DB Connector Points
282
GEH-6855_Vol_II
Jumper, JPxB
Signal Name
Connector
BPR01
PCOM
BPR02
PCOM
BPR03
PCOM
BPR04
PCOM
BPR05
PCOM
BPR06
PCOM
BPR07
PCOM
BPR08
PCOM
BPR09
PCOM
BPR10
Pin #
JA1
JA1
JA1
JA1
JA1
JA1
JA1
JA1
JB1
JB1
JB1
JB1
JB1
JB1
JB1
JB1
JC1
JC1
JC1
GEH-6855_Vol_II Mark VIeS Functional Safety Systems Volume II
Public Information
3
2
7
6
11
10
23
24
3
2
7
6
11
10
23
24
3
2
7