Table of Contents
Advertisement
HP-IB Cables and Addresses
HP-IB Addresses and Connections of the Rack Mounted Instruments
The HP-IB addresses of rack mounted instruments|the HP 4084B SWC, HP 4142B DCS, HP
4280A CMU or HP 4284A CMU84, and HP 8110A PG(s)|are set when installed in the HP
4062UX/F system cabinet at the factory. Make sure the HP-IB address of each instrument is
set correctly, as shown in Table 4-10. Refer to the
check the HP-IB address settings.
Instrument
HP 4084B SWC1
HP 4084B SWC2
HP 4142B DCS
HP 4280A CMU
HP 4284A CMU84
HP 8110A PG
For 96-pin SWM system, two SWCs are provided, the lowermost SWC in the system cabinet is SWC1,
1
and the uppermost SWC is SWC2.
An HP 4280A and an HP 4284A cannot both be installed in the HP 4062F system at the same time.
2
Depends on number of installed HP 8110As. If one HP 8110A is installed, it has HP-IB address 25. If
3
two HP 8110As are installed, they have HP-IB addresses 25 and 26, and so on.
Table 4-11 and Table 4-12 shows how to connect the system instruments to the HP-IB
interface cards in the system controller.
4-26 System Installation
Table 4-10. HP-IB Address Settings
HP-IB Address
22
1
19
1
23
24
2
17
2
25 to 29
3
Operation Manual
How to Check
Mini-rotary switches on the rear panel
Mini-rotary switches on the rear panel
Mini-rotary switches on the rear panel
Mini-rotary switches on the rear panel
Press
4
CATALOG/SYSTEM
softkey. The HP-IB
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
SYSTEM CONFIG
address setting is shown in the screen.
Press
key, then select
MORE
4
5
softkey. HP-IB address setting is shown on
the screen. You can use the rotary knob to
change the address setting.
of each instrument to
1 1 1 1 1
key and select
5
NNNNNNNNNNNNNNNNNN
CONFIG
Advertisement
Table of Contents
