Table of Contents
Advertisement
3. Remove the clear plastic cover of the power
cable terminal unit.
5. Connect the power cable to the terminals of
the power cable terminal unit.
7. Reinstall the rear opening cover.
When an Emergency Off Unit is NOT Furnished
The PDU is located at the bottom of the cabinet. The SYSTEM ON/OFF power switch is
located at the right-front of the PDU. You must connect the PDU to the power source at your
site by using your power cable.
Power source requirements depend on the electrical option installed in your system. The PDU
can accommodate one of four types of power: 100 Vac, 120 Vac, 220 Vac, and 240 Vac. The
maximum current for each PDU is shown in Table 4-3.
n
4. Pass the power cable through the hole of the
rear opening cover.
6. Reinstall the clear plastic cover on the power
cable terminal unit.
8.Fasten the power cable to the cover by turning
the cable clamp screw clockwise.
System Installation 4-5
Advertisement
Table of Contents
