Table of Contents
Advertisement
Installation of HP 4142B DC Subsystem (DCS)
This section covers hardware installation of the HP 4142B DCS into the system cabinet. For
HP 4062UX/F systems equipped with Option 405 (rack mount kit for the HP 4142B DCS),
the HP 4142B is not installed in the system cabinet, so you need to perform this installation.
Otherwise, skip the next procedure and go to \HP 4142B DCS Settings".
Installing the Customer's HP 4142B
Use this paragraph to prepare and install the HP 4142B into the HP 4062 system cabinet.
Table 4-5 shows the accessories furnished with Option 405. This table does not include the
accessories furnished with your HP 4142B.
Table 4-5. Contents of Rack Mount Kit for the HP 4142B
Item
(1)
Flange
(2)
Screw M4
(3)
Flathead Screw
(4)
Insert Washer
(5)
Cup Washer
(6)
Stopper
(7)
Screw M3.5
(8)
Interconnection Cable
Installation Preparation
To prepare the HP 4142B for installation into the HP 4062 cabinet, refer to the Figure 4-1
and perform the following procedure:
1. Remove the side strips from each side of the HP 4142B.
2. Attach the rack
anges (1) to each side of the HP 4142B using the screws (2) furnished
with Option 405.
3. Remove the 4 feet and 2 tilt stands from the bottom panel of the HP 4142B.
Description
HP Part Number
Quantity
04062-01281
0515-1013
2680-0119
3050-0248
3050-0007
09480-06051
0515-1232
04085-61684
2
6
4
4
4
2
2
1
System Installation 4-9
Advertisement
Table of Contents
