Table of Contents
Advertisement
Required Equipment
The equipment needed to install the HP 4062 follows:
Standard Screwdriver (one large, one small)
Phillips Screwdriver
Wire Strippers
Slip-joint Pliers
Battery-powered Voltmeter
Utility Software
The system software contains the following utilities for checking the installation process:
PROBER program Checks your prober operations after installing the HP 4062UX/F system.
For details, see the following les:
check62ux
A shell procedure that checks the system software installation of the HP
4062UX/F.
Abbreviations
Throughout the HP 4062UX/F documentation, the following abbreviations are used to
identify the subsystems and instruments in the HP 4062UX/F system.
Abbreviation Term
SMS
Switching Matrix Subsystem: consists of SWC and SWM
SWC
HP 4084B Switching Matrix Controller
SWM
HP 4085B, HP 4089B, or HP 4085F Switching Matrix
DCS
DC Measurement Subsystem: HP 4142B Modular DC Source/Monitor
CMS
Capacitance Measurement Subsystem
CMU
Capacitance Measurement Subsystem: HP 4280A 1 MHz C Meter/C-V Plotter
CMU84
Capacitance Measurement Subsystem: HP 4284A 20 Hz{1 MHz Precision LCR
Meter
PCS
Process Control System
PDU
Power Distribution Unit
BASIC/UX
BASIC on HP-UX: the HP BASIC coordinated to execute on HP-UX system
/usr/pcs/etc/prober_check/READ_ME
General Information 1-3
Advertisement
Table of Contents
