Table of Contents
Advertisement
Installation of HP 8110A Pulse Source Subsystem (PSS) (HP 4062F
Only)
This section covers hardware installation of the HP 8110A pulse generator(s) into the system
cabinet. For HP 4062F systems ordered with Option 555 (rack mount kit for the HP 8110A
PG), the HP 8110A is not installed in the system cabinet, so you need to perform this
installation. If you do not need to perform this installation, skip the next procedure.
Installing the Customer's HP 8110A
To use HP 8110A as a pulse source subsystem of the HP 4062F system, the requirements
listed in Table 4-8 must be met. This table also describes how to check if the requirements are
met.
Table 4-8. Requirements of HP 8110A for the HP 4062F
HP 8110A Option UN2 \Rear Panel
Connectors" must be used. This moves the
input and output connectors from front
panel to rear panel.
One or two HP 81103A \10 V/2 ns Output
Channel" must be installed in the HP
8110A.
An HP 81106A \PLL/External Clock"
must be installed in the HP 8110A.
Firmware revision of the HP 8110A must be
.
01.05.00
Table 4-9 shows the accessories furnished with Option 555. This table does not include the
accessories furnished with your HP 8110A.
Requirements
How to Check
See the rear panel of the HP 8110A. The
HP 8110A has the BNC female connectors
on the rear panel.
Turn your HP 8110A on, press
select
. Installed HP 81103A(s)
NNNNNNNNNNNNNNNNNNNNNNNN
SERIAL #
are listed.
Turn your HP 8110A on, press
select
. Installed HP 81106A is
NNNNNNNNNNNNNNNNNNNNNNNN
SERIAL #
listed.
Turn your HP 8110A on, press
select
. The rmware revision
NNNNNNNNNNNNNNNNNNNNNNNN
SERIAL #
number is shown.
1 1 1 1 1
, then
4
Help
5
, then
Help
4
5
, then
4
Help
5
System Installation 4-19
Advertisement
Table of Contents
