Toshiba GL-1010 Administrator's Manual page 68
Toshiba gl-1010 office mfp
Hide thumbs
Also See for GL-1010:
- Operator's manual (126 pages) ,
- Network fax manual (98 pages) ,
- Network fax operators manual (88 pages)
Table of Contents
Advertisement
If this screen does not open, the controller did not boot from the CD
successfully.
5
Press
the CD to the hard drive. This process takes approximately five
minutes, during which time the touch screen displays the OS Update
Progress screen.
6
When the system update process completes, the CD-ROM is ejected
and the touch screen displays Press the START key to start
controller.
7
Remove the CD-ROM from the drive and press the
must remove the CD-ROM before the controller can boot up.
8
After boot up, an initialization process begins. This takes
approximately 10 minutes. During that time, the touch screen
displays Processing Controller update, don't switch off.
9
When communications with the copier resume, a test page prints out
on the copier and the front panel becomes operational again. The
controller software version printed on the test page should match the
update version. If so, the system update has completed successfully.
If you experience problems during the update process, or if the
system does not come back online after the update process
completes, contact your Toshiba authorized dealer for support.
Update OS From Control Panel
1
Press the
2
Press the
3
Log on to perform administrative functions.
46
to continue. The controller begins copying the software from
OK
PRINTER/NETWORK
tab.
ADMIN
hard key on the copier control panel.
GL-10x0 Administrator's Guide
button. You
START
Advertisement
Table of Contents
Troubleshooting
