Toshiba GL-1010 Administrator's Manual page 236
Toshiba gl-1010 office mfp
Hide thumbs
Also See for GL-1010:
- Operator's manual (126 pages) ,
- Network fax manual (98 pages) ,
- Network fax operators manual (88 pages)
Table of Contents
Advertisement
H
P
OLE
UNCH
3
If the hole-punch option is installed in the finisher unit, turn on hole-
punching using the Hole-Punch drop-down list.
The options include:
without rotation
with 180 degree rotation
4
If you are finished, click
S
TAPLING
5
Select the staple position from the Stapling drop-down list.
The staple position values may not be valid for all paper sizes and
feed directions. The PPD file does not record if the print job is portrait
or landscape, therefore it cannot offer different options depending on
the print direction.
The saddle stitching option folds the document in half and places two
staples along the fold. This option is used in conjunction with booklet
mode.
When the finisher is not installed the stapling options are still present
but have no effect if selected. If the single position stapler is installed
only the
214
,
Off
Long Edge Punch without rotation
,
Long Edge Punch with 180 degree rotation
. The default for this option is
CUPS Hole Punch Options
Continue
CUPS Stapling Options
option has at effect if selected. The stapling
Upper Left (Portrait)
, and
.
GL-10x0 Administrator's Guide
,
Short Edge Punch
Short Edge Punch
.
Off
Advertisement
Table of Contents
Troubleshooting
