Toshiba GL-1010 Administrator's Manual page 143
Toshiba gl-1010 office mfp
Hide thumbs
Also See for GL-1010:
- Operator's manual (126 pages) ,
- Network fax manual (98 pages) ,
- Network fax operators manual (88 pages)
Table of Contents
Advertisement
2
On the Administration tab, click the
opens.
3
Click the
4
In the DDNS area, click the down arrow beside the
Dynamically
5
Select
6
Enter the host name of the DNS server in the
is disabled if DDNS is disabled. The default value for this field is the
MAC address of the controller.
7
Scroll down to the bottom of the page and click
settings.
Alternatively, click
values.
8
Reboot the controller for the changes to take effect.
Configuring SMB Settings
If you are using the SMB networking protocol for any wireless network
traffic involving the controller, you must enable the SMB protocol on the
wireless NIC. The SMB protocol is enabled by default. If you are not using
SMB for any wireless network traffic, disabling the SMB protocol on the
wireless NIC reduces overhead and improves efficiency.
1
Log in as an administrator.
2
On the Administration tab, click the
3
Click the
4
In the SMB area of the Wireless Network page, click the
down list.
5
Select
6
In the
7
Enter the name of the
8
Enter the address of the
9
Enter a
10 To set the controller as a master browser, click the
down list and select
11 Click
Administrator's Guide
GL-10x0
Wireless Network
pull-down list box.
to enable DDNS or
Enable
Reset
Wireless Network
to enable the SMB protocol.
Enable
field, enter the controller name.
Device Name
Workgroup
for the controller.
WINS Scope ID
Enable
.
Save
Setup
link. The Wireless Network page opens.
to disable DDNS.
Disable
to reset all settings on this page to the default
Setup
link. The Wireless Network page opens.
the controller belongs to.
Primary WINS Server
.
subtab. The Setup page
Update DNS
field. This field
Host Name
to save your
Save
subtab.
Protocol
.
Master Browser
drop-
drop-
121
Advertisement
Table of Contents
Troubleshooting
