Sony DVS-9000 User Manual page 502
Production switcher system
Hide thumbs
Also See for DVS-9000:
- User manual (1228 pages) ,
- Installation manual (42 pages) ,
- Operation manual (24 pages)
Table of Contents
Advertisement
• Individual events stored in a macro are executed according to the settings in
setup. If you change the settings in setup, a saved macro may not have the
expected effect.
• During macro execution, if you switch the control panel to macro editing
mode, the macro being executed stops.
• During macro editing, pressing a button for which a macro attachment is set
does not execute the macro.
To disable macro attachment settings
Depending on the location of the button you want to disable, press the [MCRO
ATTCH ENBL] button, turning it off.
In this state, pressing a button for which a macro attachment is set does not
execute the macro.
Executing a macro assigned to a fader lever
1
In the cross-point control block for the fader lever on which you want to
execute the macro, press the [MCRO ATTCH ENBL] button, turning it on.
2
Move the fader lever from the start position to the end position.
When the fader lever passes the position at which the macro attachment is
set, the macro register is recalled, and the macro is executed.
Notes
• Unless you move the fader lever to the end position (completing the travel),
it is not possible to execute the macro again.
• When the preset color mix stroke mode is Normal (see page 372), the first
lever operation executes the macro, but the second lever operation does not.
• During macro execution, it is not possible to execute another macro.
• Individual events stored in a macro are executed according to the settings in
setup. If you change the settings in setup, a saved macro may not have the
expected effect.
• During macro execution, if you switch the control panel to macro editing
mode, the macro being executed stops.
• During macro editing, even if you operate a fader lever with a macro
attachment set, the macro is not executed.
To disable a macro attachment setting
In the cross-point control block for the fader lever on which you want to disable
the macro, press the [MCRO ATTCH ENBL] button, turning it off.
In this state, operating a fader lever with a macro attachment set does not
execute the macro.
Macro Attachment Assigning
501
Advertisement
Table of Contents
