Sony DVS-9000 User Manual page 280

Production switcher system

Hide thumbs Also See for DVS-9000:

Table of Contents

Selecting the state at start-up

In the status area of the System >Start Up menu, select the device to which

the settings are to apply.

In the <Start Up Mode> group, select one of the following modes.

Resume: When this is on, Resume mode is enabled.

Custom: When this is on, Custom mode is enabled.

For information about Resume mode and Custom mode, see "System

Setup" in Chapter 1 (Volume 1).

The Resume mode is only valid when a switcher or control panel is

selected for the setting.

When Custom mode is selected, in each of the <Setup> group and <Initial

Status> group, select one of the following.

User: When this is on, user-defined settings are used for the Setup or

Initial Status settings. For the method of saving the user-defined

settings, see the next item.

Factory: When this is on, factory default settings are used for the Setup or

Initial Status settings.

To confirm the settings, press [Execute]. If you want to cancel the setting

changes without saving them, press [Clear].

When [Execute] is pressed, a confirmation message appears.

Select [Yes].

The start-up state settings are saved.

Saving user-defined settings

To save the Setup settings

After selecting the devices to which the settings apply to, in the System

>Start Up menu, press [Setup Define].

A confirmation message appears.

Press [Yes].

Setup for the Whole System