Installation And Device Setup (Install/Unit Config Menu) - Sony DVS-9000 User Manual
Production switcher system
Hide thumbs
Also See for DVS-9000:
- User manual (1228 pages) ,
- Installation manual (42 pages) ,
- Operation manual (24 pages)
Table of Contents
Advertisement
Resetting the device and initializing memory
1
In the status area of the System >Initialize menu, select the device to which
the settings are to apply.
2
In the <Initialize> group, select one of the following modes.
Reset: Reset the device.
All Clear: Initialize memory.
3
Press [Execute].
A confirmation message appears.
4
Select [Yes].
Depending on the selection in step 2, the following is the result.
• When you selected [Reset], a reset is applied to the device causing it to
be restarted in the start-up state.
• When you selected [All Clear], all memory in the device is cleared,
including snapshots, keyframe effects, setup, and so on, and the device
returns to its factory default settings. However, the Network Config,
Format, Start Up, and Date/Time settings are not initialized.
Installation and Device Setup (Install/Unit Config Menu)
To install software or firmware in a device, use the System >Install/Unit
Config menu.
To display the Install/Unit Config menu
In the Engineering Setup menu, select VF1 'System' and HF6 'Install/Unit
Config.'
The status area shows the version of the software and the firm ware installed in
each device.
Installing software
1
Insert the memory card holding the software into the memory card slot.
2
In the System >Install/Unit Config menu, press [Install].
The Install menu appears; the status area shows the following information.
Upper list: For each connected device, this shows the device name,
current software version (Current), and the latest version that can be
installed (Install, Title).
Setup for the Whole System
281
Advertisement
Table of Contents
