Sony DVS-9000 User Manual page 357
Production switcher system
Hide thumbs
Also See for DVS-9000:
- User manual (1228 pages) ,
- Installation manual (42 pages) ,
- Operation manual (24 pages)
Table of Contents
Advertisement
3
356
Setup Relating to Operations From the Control Panel
Operation mode of the [ALL] button in the transition control block:
To specify the next transition to be selected by pressing the [ALL]
button in the transition control block, press the next transition you
want to select, turning it on, in the <Next Trans All> group. If
everything here is set to Off, then pressing the [ALL] button does not
change the specification of the next transition.
Operation mode during an auto transition: For the operation mode
when the [AUTO TRANS] or [TAKE] button is pressed once more
during an auto transition, select [Continue] or [Cancel] in the <Auto
Trans/Take> group.
Continue: Continue the auto transition.
Cancel: Cancel the auto transition and return to the state before
starting the auto transition.
Operation mode during keyframe execution: For the operation mode
when the [RUN] button is pressed once more during effect execution,
select [Continue] or [Cancel] in the <Run> group.
Continue: Continue the execution.
Cancel: Cancel the execution and return to the state before starting the
execution.
Interchanging the [AUTO TRANS] and [CUT] buttons: To
interchange the [AUTO TRANS] and [CUT] buttons in the transition
control block, press the [Auto Trans/Cut Swap] button, turning it on.
Transition preview operation mode: For the operation mode of the
[TRANS PVW] button, select [Lock] or [Hold] in the <Trans Pvw>
group. The setting as to whether to use the "One-time mode" in which
the transition preview terminates when the transition completes, or to
use button control, is made on the switcher side (see page 371).
[KEY] button operation mode for key source bus operations: When the
key source bus is selected with the delegation buttons in the AUX bus
control block, specify the [KEY] button operation mode in the <Key
Source Bus Select Mode> group, as follows.
Key: If you select this, the [KEY] button is always lit, and this mode
allows only key signals to be selected with the cross-point buttons.
Video & Key: The [KEY] button is enabled, and either video or key
signals can be selected.
CCP-8000-specific button settings: Press [CCP-8000 Button], and skip
to step 3.
If required, make the following settings.
Operation mode during a fade-to-black: To set the operation mode if the
[FTB] button is pressed once more during a fade-to-black, select either
of the following in the <FTB> group.
Continue: Continue the fade-to-black.
Cancel: Cancel the fade-to-black, and return to the state before
executing the fade-to-black.
Advertisement
Table of Contents
